 FS: IIDASC 2P Side
I'll post pics soon.
Just as the title says it is 2P side.
Cherry Switches.
Judging by the (what seems to be) excessive amount of wires inside the controller I'm guessing it's wired for lights. The only problem is I wasn't given a powersupply and I'm not positive what type to use, or if that's even a powerjack on top.
I've also slightly modded it so that you don't need screws to undo the bottom. This also makes it easier to move around since you can throw the cord you plug into the ps2 in there.
There are a few problems. The hinges weren't fastened too well, so whenever you open it there's a good chance it might come off altogether. The latch however that locks it on does a good job at keeping it on. If you don't care for this you can always remove the latch and hinges and just screw back on the bottom. However I don't reccomend this since it's easier to access if the controller's switches aren't firing properly due to say a loose connection or if the turntable needs to be lubed up because it's too tight etc etc.
I might bring it in tommorrow to my family's hardware store and see about getting some screws to use for the hinges instead of these nails.
Cosmetically it's flawed as well. On the bottom side there's a small part where the wood is starting to chip and peel off. It's still attached though. I'll post pics soon.
Given condition I'm open to offers. I'd like to get something like $225 + shipping. I'm usually on AIM (PushStartButton) if you'd like to talk to me directly about it. | 
